Floriani Heat N Gone Topping 20" x 10 yds - FHG2010
Floriani Heat N Gone Topping 20" x 10 yds - FHG2010
To use as a topping:
- Place a piece of Floriani Heat N Gone on top of the hooped item, bumpy side down, and secure with pins or tape.
- Once the embroidery is complete, tear away as much of the Heat N Gone as possible.
- Place your heated iron to the top of the garment to remove the excess stabilizer.
- Be sure your iron temp is a least 260° F (120°C).
To use as a stabilizer:
- Place a piece of Heat N Gone within the hoop with the item to be embroidered.
- Use a piece at least one inch larger than the outer perimeter of the hoop.
- The bumpy side of the stabilizer should be against the fabric.
- Once the embroidery is complete, tear away as much of the Heat N Gone® as possible.
- Follow the steps above for removing any remnants left around the design